Hi!
Just started the SD interrupter assembly.
The instruction tells R9 should be 100ohm.
- it is labelled 1k on the board
- it is 1k on the schematic in the download section on the website
- it is 1k on the board layout on the website
- I received it as 1k, so I miss one 100ohm resistor!
Do you confirm the proper contrast will be achieved by a R9 value of 100ohm?
Thanks.
- It is currently Sun Oct 20, 2019 11:57 pm • All times are UTC - 5 hours
Need a help
3 posts
• Page 1 of 1
Need a help
by MaxP » Sat Sep 28, 2019 12:54 pm
- MaxP
- Tipsy Toggle Switch
- Posts: 1
- Joined: Sat Sep 28, 2019 12:53 pm
Re: Need a help
by Bayley » Thu Oct 03, 2019 12:26 am
1K is the correct value for the current LCD modules.
-
Bayley - Lord Protector
- Posts: 1286
- Joined: Sat Jan 12, 2013 6:34 pm
Re: Need a help
by NelonPascal » Mon Oct 14, 2019 1:42 am
For the details you shared, 1K is ok, Thanks
- NelonPascal
- Tipsy Toggle Switch
- Posts: 2
- Joined: Wed Oct 09, 2019 2:36 pm
3 posts
• Page 1 of 1
Return to Anything else for discussion?
Who is online
Users browsing this forum: No registered users and 1 guest