Page 2 of 2

Re: oneTesla OCD!

PostPosted: Sat Jan 18, 2020 11:47 am
by ProtonX
Main question: Can someone tell me where to connect input and output in my oneTesla TS driver?

By the way: I would also be interested in information about the current sensing toroids. How are they connected and in which directions do I have to wind them? I would like to build this part on my own.

Does anyone know the electrical reason why there need to be 2 toroids while the primary loop only goes through on of them? Is it something about the correct phase?


Re: oneTesla OCD!

PostPosted: Tue May 05, 2020 9:09 am
by Drake12321
very cool, now I’ll sit down and try to make such a board!